PLASTIGRIT - PA
PLASTIGRIT
is the filament suitable for
production of abrasive
brushes, which are used in a variety of applications and provide both
aggressive treatements and aesthetic finishings.
Our abrasive filaments PLASTIGRIT are manufactured from Polyamide
polymer 6.6 or 6.12 ,with the addition of a charge of
up to 30%
of silicon carbide (SIC)
or aluminum oxide
(AL2O3).
The formulation
with
Polyamide 6.0
is recommended for dry
applications, whereas the
formulation with Polyamide
6.12, is suitable for
any use.
The formulation
with
silicon carbide
(SIC)
is recommended for high
abrasion applications. Aluminum
Oxide (AL2O3)
can be used for less aggressive
sandings
on softer materials.
Only highest quality raw materials and additives are used, in order to
provide and guarantee excellent stifness and bend recovery properties.
PLASTIGRIT
is subjected to a severe
heat stabilization, accurate diameter check
and control of grit distribution. These operations ensure that
the filaments are given excellent abrasive properties,
consistent performance and
long lifetime, even under the
most extreme working conditions.
Our
standard product,
available both in level and crimped version,
is supplied in hanks 1200 mm long with surface
lubrication. The cut length
can be changed according to specific
requirements.
The PLASTIGRIT product family is
divided into four main
product groups, based on their
use and on the required
degree of abrasion:
H
- Hard -
High Abrasion
(
24-36-46 grit)
M - Medium
-
Medium
Abrasion
(60-80-120
grit)
L - Light
- Light Abrasion
(180-240-320 grit)
EL
- Extra Light
- Extra Light Abrasion / Finishing and
polishing
(500
grit)
|